News & Insights

DC power distribution is the reliability foundation of an edge or headend site. Learn why the power plant, not the electronics, is the usual point of failure, and how fusing and capacity decide uptime.

By 2019 Amphenol had assembled a broadband portfolio spanning coax, RF, fiber and network infrastructure. One piece was missing: outside plant protection. The acquisition of Charles Industries supplied it.

Migrating from HFC to 10G-PON/25G-PON is the defining network transition of this decade — and the good news is operators can do it on the same fiber, not a parallel […]

Pre-connectorized fiber turns skilled field splicing into plug-and-play. Learn how factory-terminated assemblies beat the labor gap and compress fiber build schedules.

The FTTH drop is the most repeated task in a fiber build, and where cost concentrates. Learn how pathway, drop, and terminal choices make the last 100 feet fast to install and cheap to upgrade.

A fiber splice closure protects the network’s most vulnerable point. Learn how sealing, contamination control, and strain relief prevent the outages that start at the joint.

Rising fiber counts turn cable management into a performance and uptime issue. Learn how bend radius quietly erodes your optical budget and what to design in so a high-count site stays reliable.

A cable run is a handful of long, stable spans. A network is thousands of small joints. Learn why the interface fails before the cable does, how moisture drives it, and what to spec for coax connector reliability.

The hardline connector is a rounding error on your bill of materials and a top line item on your maintenance ledger. Learn how a loose grip or corroded joint turns a connector into a tiny diode — and why the noise it creates surfaces nowhere near the fault.

RF signal integrity decides how much of your spectrum you can actually sell. Learn how passive intermodulation, return loss, and isolation set the noise floor your network lives above — and why amplifiers can never fix it.